Agri Vehicles Insurance from Greenlands

Author Topic: Wire tensioning buckle  (Read 193 times)

bwms

  • Joined Oct 2020
Wire tensioning buckle
« on: October 27, 2020, 12:59:16 pm »
Hi All,

I've been dipping into your forum for a year now.  I have a 1.5 acre plot made up mostly by two paddocks at either side of my 1980's bungalow.  The land has been abandoned for few years and it's been a learning curve trying to get things into shape.  To be honest it's damage limitation whilst I get the house refurbished.

I've a few wire fences that sare sagging.  They have rachet buckles that can be turned to take up some slack.  My usual sockets don't fit the square peg on the buckle.  In my head there is a special wrench tool for the job, or did I just imagine it?

Any suggestions appreciated :-)

Dan

  • The Accidental Smallholder
  • Administrator
  • Joined Oct 2007
  • Carnoustie, Angus
    • The Accidental Smallholder
    • Facebook
Re: Wire tensioning buckle
« Reply #1 on: October 27, 2020, 02:11:29 pm »
Welcome to the forum!

Those are called radisseurs, and I just use an adjustable spanner for turning the spindle, and a nail to slip through the retaining holes if it's not the rachet type.

For any new fencing I now use Gripples - pricier to get setup, but much easier to install and re-tension.

Hope this helps.

captainmark

  • Joined Dec 2017
Re: Wire tensioning buckle
« Reply #2 on: October 29, 2020, 08:26:35 am »
agree with the gripples - easy to use. I have used to tension existing by cutting a section out and replacing with new piece of wire / 2 gripples.  (my wires already have gripples but the clown who installed didn't leave the tails long enough!). imho you don't need the top end contractor quality tools.  I bought:

https://rghsupplies.co.uk/products/gripple-plus-starter-pack-kit-wire-tensioning-torq-tool-50-medium-wire-joiners?_pos=1&_sid=1abcd17c1&_ss=r

https://rghsupplies.co.uk/products/gripple-release-key?_pos=1&_sid=7f8a6a84c&_ss=r

And for 'nice bodging' to older existing where gripples not suitable have found this invaluable too:

https://www.toolstation.com/fence-wire-tensioning-tool/p91413?store=A5&utm_source=googleshopping&utm_medium=feed&utm_campaign=googleshoppingfeed&gclid=EAIaIQobChMIusOrzK_Z7AIVxbHtCh3VvwTNEAQYASABEgLvxPD_BwE

 

Joining rolls of hex' wire mesh - best way?

Started by arobwk

Replies: 8
Views: 4970
Last post April 16, 2017, 08:13:41 pm
by macgro7

Forum sponsors

FibreHut Energy Helpline Thomson & Morgan Time for Paws Scottish Smallholder & Grower Festival Ark Farm Livestock Movement Service

© The Accidental Smallholder Ltd 2003-2020. All rights reserved.

Design by Furness Internet

Site developed by Champion IS