The Accidental Smallholder Forum
Livestock => Sheep => Topic started by: vfr400boy on April 17, 2020, 10:30:07 pm
-
After looking for a small sheep trailer and been unsuccessful iv decided to modify a normal 6x4 trailer, my question is how tall dose it have to be ? Am thinking 4ft , but that's just a guess ?
Am making a lift on and off roof out of box section and alloy sheet so light weight but still strong
-
Hiya, our Ifor p7e has an internal height of just under four feet, so your first guess seems pretty good to me!
-
I was measuring the dog this morning trying to work out how much space I needed ha ! Thanks
I will show you a picture when I get it finished
-
So iv got all the frame work built and tin sheets ordered for my roof
My question is I have a 28 inch gap to fill up the side of the trailer was going to use 6x1 timber and maybe a 2x1 at the top
How much gap do I need in between each bored if any ?
-
Pic from today
-
All painted
-
Finished
-
I would be a little concerned with all the screw/bolt ends sticking out as they could cause some nasty cuts.
-
Agreed, easy enough to cut the ends off with an angle grinder
-
Photo was taken when it was not quite finished ha all ground off and painted again!
-
Finally got our sheep ! Am very happy with them got them on Sunday and they doing very well so far
-
All 4 of them
-
Look grand and the trailer did its job! :excited: